Walker 5600-20 Owner's Manual

OM 0182BR47-A 02/09 OOPPEERRAATTOORR''SS AANNDD PPAARRTTSS MMAANNUUAALL 47" (1.2 M) ROTARY BROOM MODEL 6650

SAFETY PRECAUTIONS - continued OM 0182BR47-A 8MAINTENANCE ALWAYS USE GENUINE PARTS WHEN REPLACEMENT PARTS ARE REQUIRED 1. Keep the tractor and r

DECALS 9 Replace immediately if damaged 660988 660328 661051 658708 2500515 2500584

ASSEMBLY OM 0182BR47-A 10 HITCH INSTALLATION – TRACTOR SIDE Before installing this hitch make sure engine is off and parking brake is set. Attaching Q

ASSEMBLY OM 0182BR47-A 11 3. Figure 5: Drill five 13/64” (5 mm) dia. holes in the tractor: two in the forward speed control arm and three in t

ASSEMBLY OM 0182BR47-A 12ROTARY BROOM ASSEMBLY The rotary broom is assembled at the factory, however, parts contained in the bag must be installed. U

ASSEMBLY OM 0182BR47-A 13 7. Put the pivot lock pin (fig. 10, item A) in the outermost position and secure with the hairpin. WARNING: To av

ASSEMBLY OM 0182BR47-A 14LAWN DETHATCHING WHEEL KIT - WAL0001 (OPTION) Installation (Figure 11) 1. Remove the parking stands (item 9) from t

OPERATION OM 0182BR47-A 15 GENERAL PREPARATION 1. Check drive shaft tightening. 2. Make sure that the broom operates freely. 3. Adjust the lawn

OPERATION OM 0182BR47-A 16 Ground Pressure Adjustment (Figure 12) This adjustment must be made when the broom is attached to the tractor. IM

OPERATION OM 0182BR47-A 17 General Sweeping IMPORTANT: Always use the float position when working with the broom. 1. Minimize dust by reducing

Foreword Thank you...for purchasing a Walker rotary broom. Every effort has been made to provide you with the mo

MAINTENANCE OM 0182BR47-A 18 MAINTENANCE ALWAYS USE GENUINE PARTS WHEN REPLACEMENT PARTS ARE REQUIRED. 1. Avoid exposing broom bristles to

MAINTENANCE OM 0182BR47-A 19Chain Replacement (Figure 13 & 13a) Replace the chain when the distance between the spans is reduced to 1 3

MAINTENANCE OM 0182BR47-A 20Figure 15 Brush Replacement (Figures 15 & 15a) When the brushes reach a diameter of 10" (254 mm), it is ne

MAINTENANCE OM 0182BR47-A 21A Figure 15a 10. SNUG FIT : To ensure a correct fit of the wafer assembly on the brush support, make sure to respec

MAINTENANCE OM 0182BR47-A 22LUBRICATION Use a grease gun, grease and lubricate as follows: DESCRIPTION TIME INTERVAL LUBRICATION REQUIRE

MAINTENANCE OM 0182BR47-A 23 Lawn Dethatching Wheel Kit Use a grease gun, grease and lubricate as follows: DESCRIPTION TIME INTERVAL LUBRICATION

MAINTENANCE OM 0182BR47-A 24STORAGE Before storing the rotary broom, certain precautions should be taken to protect it from deterioration. 1.

PARTS OM 0182BR47-A 25 INTRODUCTION All parts are illustrated in "exploded views" which show the individual parts in their normal rela

PARTS OM 0182BR47-A 26 MALE QUICK HITCH ASSEMBLY - 6625 REF. DESCRIPTION QTY PART NUMBER 1 Male quick hitch 1 660980 2 Quick hitch latch 1

PARTS OM 0182BR47-A 27 MALE QUICK HITCH SYSTEM REF. DESCRIPTION QTY PART NUMBER 1 Adaptor 1 6620-27 2 Grease fitting 45°. 2 5830-3 3 Hex.

TABLE OF CONTENT OM 0182BR47-A 1 INTRODUCTION – TO THE PURCHASER ...

PARTS OM 0182BR47-A 28 ROTARY BROOM ASSEMBLY – 6650-B

PARTS OM 0182BR47-A 29 ROTARY BROOM ASSEMBLY – 6650-B REF. DESCRIPTION QTY. PART # 1 Housing 1 ------- 2 Right side plate 1 667841 3 Brush

PARTS OM 0182BR47-A 30 ROTARY BROOM ASSEMBLY – 6650-B REF. DESCRIPTION QTY. PART # 40 Nylon insert lock nut 1/4" NC, PTD 1 O/L 41 Hex. bo

PARTS OM 0182BR47-A 31 PIVOT BRACKET & FEMALE HITCH ASSEMBLY REF. DESCRIPTION QTY. PART # 1 Broom pivot 1 667605 2 Female hitch 1 667129

PARTS OM 0182BR47-A 32 DRIVELINE ASSEMBLY MALE PORTION 6651 REF. DESCRIPTION QTY. PART # 1 Outer shield 1 6651-1 2 Nylon bearing 1 6651-2 3

PARTS OM 0182BR47-A 33GEAR BOX - 4500024 REF. DESCRIPTION QTY. PART # 1 Casing 1 664659 2 Bolt M8 x 45 8 0200098 3 Hex. nut M8 8 0900029

PARTS OM 0182BR47-A 34 LAWN DETHATCHING WHEEL KIT – WAL0001 (OPTION) REF. DESCRIPTION QTY PART # 1 Wheel support LH 1 666941 2 Wheel support RH

AVAILABLE OPTION OM 0182BR47-A 35 LAWN DETHATCHING WHEEL KIT WAL0001

AVAILABLE EQUIPMENT OM 0182BR47-A 36 36" (.91 m) ONE STAGE SNOWBLOWER 5600-20 42" (1.07 m)TWO STAGE SNOWBLO

TORQUE SPECIFICATION TABLE OM 0182BR47-A 37 GENERAL SPECIFICATION TABLE Use the following torques when special torques are not given. Note: These val

TABLE OF CONTENT OM 0182BR47-A 2 MAINTENANCE...

WALKER MANUFACTURING CO. 5925 E. Harmony Road Fort Collins, CO 80528 USA Printed in Canada

INTRODUCTION OM 0182BR47-A 3 TO THE PURCHASER All products are designed to give safe, dependable service if they are operated and maintain

SAFETY PRECAUTIONS OM 0182BR47-A 4 SAFETY FIRST This symbol, the industry's "Safety Alert Symbol", is used throughout thi

SAFETY PRECAUTIONS - continued OM 0182BR47-A 5NOTICE A safe operator is the best assurance against accidents. All operators, no matter how experie

SAFETY PRECAUTIONS - continued OM 0182BR47-A 6Rotary Broom & Subframe Operation 1. Before leaving the tractor unattended, take all possible pre

SAFETY PRECAUTIONS - continued OM 0182BR47-A 720. Never allow anyone to operate the rotary broom until they have read the manual completel